Top 10 usual forklift crashes ， forklift procedure need to take notice of these issues ！.

Don't underestimate the forklift at the office. If the operation is not good, there will be major mishaps in minutes, and there are lots of accidents entailing forklifts.

Situation 1: The forklift cargo blocked the driver's view, and the person in front can not be found, resulting in a moving crash.
Case 2: In order to maintain the equilibrium of the forklift when raising heavy goods, the staff members used their body weight as the counterweight, which almost created casualties.
Situation 3: The size of the forklift cargo goes beyond the permitted width of the course and hangs on the roadside rack, which virtually creates an mishap.
Situation 4: Forklift is speeding up and surrender during a turn.
Situation 5: The forklift chauffeur did not observe the pedestrian, and the pedestrian did not see the forklift.
Case 6: The forklift raises the employees illegally, the forklift chauffeur does not put on the safety belt, the forklift lifter drops and the motorist is squashed when the forklift rolls over.
Case 7: The forklift driver did not wear a safety belt and fell from the car when it rolled over and was crushed.
Forklift operation must pay attention to these issues ：.

Beginning.
1. Prior to beginning, observe the surroundings, and after confirming that there are no barriers that hinder the safety and security of driving, beep the horn initially and afterwards start.
2. For automobiles with hydraulic (air pressure) brakes, the brake hydraulic pressure (air pressure) scale have to be secure before starting.
3. When the forklift starts with a load, the motorist needs to initially verify that the tons is steady and reliable.
4. The start must be slow and steady.

Driving.
1. When driving, the elevation between the bottom end of the fork and the ground need to be maintained 300mm-400mm, and the pole should be tilted in reverse. .
2. Do not raise the fork too expensive when driving. When going into and leaving the work website or while driving, be careful that there will certainly be no barriers in the sky. When the lots is taking a trip, the fork needs to not be raised expensive, which will certainly impact the security of the forklift. .
3. After discharging, the fork needs to be decreased to the regular driving placement before driving. .
4. When transforming, if there are pedestrians or automobiles nearby, the driving signal ought to be provided initially. High-speed sharp turns are prohibited. High-speed sharp turns will certainly trigger the lorry to shed lateral stability and topple. .
5. When the forklift is downhill, it is strictly forbidden to switch off the flame and slide, and it is forbidden to brake unexpectedly while driving with lots unless there are special situations.
6. When the forklift is running, it must comply with the web traffic rules in the factory and should maintain a specific safety and security distance from the lorry in front. .
7. When the forklift is running, the tons needs to remain in the most affordable position that does not hinder the driving, and the gantry ought to be appropriately slanted back. The lots will not be increased other than when piling or packing. .
8. The height of the tons should not block the chauffeur's sight. In special conditions, when the thing influences the forward vision, drive at a reduced speed when reversing.
9. It is forbidden to turn on the ramp, nor to drive throughout the ramp. .
10. The secure driving rate of the forklift in the factory area is 5 km/h, and it must drive safely at a reduced rate when going into the production workshop location. .
11. When the forklift is raised, lifted or driven, it is forbidden for employees to depend on the fork to hold products and play a balancing role. .
12. If troubles are discovered, they will be fixed and reported in a prompt way, and they will never ever operate with illnesses or hide them.

packing and unloading.
1. When fork-loading items, the range between both forks must be adjusted as required to make the tons of the two forks well balanced and not skewed, and one side of the thing must be against the shelf. .
2. It is prohibited to work with a solitary fork or use a fork top or draw. In special circumstances, safety and security warning signs must be established to remind bordering pedestrians. .
3. In the process of loading and dumping items, the forklift has to be braked with the brake. .
4. The rate of the car need to be sluggish and steady. Beware not to roll the wheels on the dunnage, so as not to extend the rolled items and injure people. .
5. When making use of a fork to fork the goods, the fork ought to be as deep as feasible under the load, and it must be kept in mind that the fork suggestion need to not touch other products or things. The load must be maintained with very little back tilt of the gantry to make sure that the load does not move in reverse. The mast can be tilted ahead a little when the load is reduced to permit easy placement of the lots and removal of the forks. .
6. It is forbidden to fork products at broadband and collide with hard items with the fork head. .
7. When the forklift is functioning, it is restricted for people to stand around the fork, so regarding stay clear of the collapse of the goods and injure people. .
8. Overwhelming is forbidden, and it is prohibited to use forks to lift workers to take part in high-altitude procedures to avoid high-altitude falling mishaps. .
9. It is not enabled to utilize the brake inertia to slide, place, round or roll things. .
10. It is not permitted to use forks to pick, turn pallet unload.

Leaving .
1. It is forbidden to leave the forklift when the products on the fork are in the air. Before leaving the forklift, you need to discharge the goods or reduced the fork framework.
2. Draw the emergency brake take care of to dead or dispirit the hand brake button.
3. The engine is switched off and the power is removed. (Except for unique scenarios, such as the motorist does not leave the lorry's line of sight and does not exceed 1 min).
4. Get rid of the trick. .

Forklift Operation Precautions.
1. Prior to and after the forklift procedure, the appearance ought to be checked, and fuel, lubing oil and air conditioning water must be included.
2. Inspect Stand-on Electric Pallet Stacker the safety performance of beginning, running and stopping.
3. Inspect whether the lights and horn signals are total and effective.
4. Throughout the procedure of the forklift, inspect whether the pressure and temperature are regular.
5. After the forklift is running, the exterior leakage needs to additionally be inspected and the seals ought to be replaced in time.

Forklift Safety Operation Specifications.
1. You have to inspect prior to leaving the cars and truck;.
2. When you come across somebody in front of you throughout driving, you ought to send a signal at a distance of 5 m;.
3. The driving rate in the factory does not exceed 5 km/h;.
4. When driving, the nadir Stand-on Electric Pallet Stacker of the cargo need to be 0.3 m ~ 0.4 m in the air;.
5. The turning need to not be as well sharp to prevent the propensity of " totally free switching";.
6. Adding and down the slope must be slow and consistent, and no switching on the incline is enabled.
7. Do not drive across the gradient. When the gradient is above 10%, the car should be driven in reverse when going downhill;.
8. When the forklift employees carry the goods and move on, if they come across large or heavy items and go to the vehicle driver's line of vision, they need to take the reversing workout
.
The "Eight Prohibitions" should be adhered to in the operation.
1. Single fork procedure is not allowed.
2. It is not enabled to raise the goods for long distance driving.
3. It is not permitted to pick up the goods by handing over the pallet with the fork.
4. It is not permitted to directly shovel chemicals, flammables and other unsafe chemicals with forks.
5. It is not allowed to utilize inertia pressure to grab the goods.
6. It is not allowed to utilize stopping force to exile round or easy-to-roll items.
7. It is not permitted to bring people to deal with the pallet or fork, and it is purely restricted to stand under the fork after the fork is raised.
8. Do not drive laterally on slopes
.
Parking is not permitted under the list below problems.
1. Contours, slim roads, railway crossings;.
2. Sections with a longitudinal slope above 5%.
3. When there is an barrier on one side of the roadway, the opposite side of the section with the same length as the challenge must be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844